Miter   Saws
WARING

To avoid injury from an accidental start ,turn the switch OFF and always remove the plug from the power source before making any adjustments.

Consult your  vendor if for any reason the motor will not run
MOTOR
PROBLEM PROBABLE CAUSE SUGGESTED CORRECTIVE ACTION
Brake does not stop

Blade within 6 seconds.
  1. Brushes not seated or lightly sticking.
  2. Motor brake winding overheated from use of prohibited blade/accessory or rapid on/off cycling.
  3. Arbor screw loose.
  4. Other.
  1. Inspect/clean/replace brushes. See MAINTENANCE section.
  2. Use only recommended blades/accessories. Let motor cool down.
  3. Retighten.
  4. Contact Rexon Service Center . See "TROUBLESHOOTING OF BRAKE" section.
Motor does not start.
  1. Brushes worn.
  2. Others
  1. See MAINTENANCE section
  2. Contact Sears Service Center.
Brush sparking when switch is released
  1. Normal-automatic brake working properly.
  1. None
GENERAL
PROBLEM PROBABLE CAUSE SUGGESTED CORRECTIVE ACTION
Blade hits table.
  1. adjustment of depth stops.
  1. See ADJUSTMENT section.
Angle of cut not accurate.
  1. misalignment.
  1. 2.See ADJUSTMENT section.
Can¡¦t adjust miter angles.
  1. Center bolt too tight.
  2. Lubrication dried up.
  1. Adjust.
  2. Clean and relubricate between table and base, see MAINTENANCE section.
  3. Wear eye protection.
Power head wobbles.
  1. loose pivot points.

    See bevel pivot adjustment in ADJUSTMENTS section.
Power head won not fully rise or blade guard won not fully close.
  1. Lubrication needed.
  2. Part failure.
  3. Pivot spring or guard spring not replaced properly after service.
  4. Sawdust sticking to stops.
  1. See"'LUBRICATION"section.
  2. Contact Rexon Service Center.
  3. Contact Rexon Service  Center.
  4. Inspect/clean stops.
Blade binds, jams, burns wood. rough cuts.
  1. Improper operation.
  2. Dull blade.
  3. Improper blade.
  4. Warped blade.
  1. See "BASIC SAW OPERATION "section.
  2. Replace or sharpen blade.
  3. Replace with 8-1/2"dimeter blade designed for the material being cut.
  4. Replace blade.
Tool vibrates or shakes.
  1. Saw blade not round.
  2. Saw blade damaged.
  3. Saw blade loose.
  4. Other.
  1. Replace blade.
  2. Replace blade.
  3. Tighten arbor screw.
  4. Contact Sera¡¦s service Center.
Power head hard to pull/push down.
  1. Lubrication needed.
  1. See"LUBRICATION" section

   

   

¡@